9
Step 2
Align the lower mounting bracket in the same direction as at installation, and then attach the stopper
column with the M12 hex bolt to the mounting hole in the direction where fluctuation distance is large.
For example, in the case of a truck scale, align with the traveling direction of the vehicle.
Refer to the following recommended tightening torque for the bolt used to install the stopper column.
M12 hex bolt: 76 Nm
Step 3
Temporarily secure the lower mounting bracket to the base plate and the upper mounting bracket to
the main girder respectively, referring to the figure shown below. To temporarily secure them, use M16
bolts and spring washers.
Before mounting, align the mounting brackets in the same direction as at installation.
Hex head bolt
for securing
Stopper column
Attach to the hole in the direction
where fluctuation distance is large.
Stopper column
mounting hole
Direction where
fluctuation distance
is large
(Example: Traveling direction of truck)
Direction where fluctuation distance is large
Main
girder
Upper mounting
bracket
Stopper column
Base plate
M16 bolt and spring
washer
Lower mounting
bracket
