Replace Main Circuit Board, Sensor Receiver Board, Motor, Heat Element
Main Circuit Board:
Move marked circuit board house cover and replace a new circuit board.
Sensor Receiver circuit board:
.Move marked circuit board screw and replace a new one.
Replace Heat Element:
1. Move marked wind hole cover.Take the heat element out then replace a new one.
2. Replace wind hole cover. Be sure the air seal rubber at right location to avoid wind leakage.
Replace Motor:
1. Move marked wind hole cover and motor cover. Take the motor out and then replace a new motor.
2. Replace motor cover. Be sure the motor protection rubber&foam, air seal rubber at right location.
3. Replace wind hole cover. Be sure the air seal rubber at right location to avoid wind leakage.
Sensor Receiver
Circuit Board
Wind hole cover
Heat element house
Heat element
Motor
Motor house
Main Circuit Board
Main circuit
board house
Periodic cleaning of the unit is recommended. Remove cover and clean dryer dust lint.
Stainless steel is highly resistant to rust, but there are some very strict cleaning and maintenance rules
to be followed to prevent damage to its appearance.
Apply neutral detergents formulated for these purposes (non-ionic surfactants and citric acid).
Apply the detergent with soft cloth. Be careful with abrasive cloths. They may scratch the surface.
Rinse with water until all the detergent has gone.
Residue from hygiene products, liquid soap, shampoos, bath gel, etc, can also damage surfaces.
Rinse the surface with plenty of water after use.
Limescale stains can be prevented by drying the surface with a soft cloth after use.
