7.1.2.
Instrument Settings - Shunt Position - PROGRAM MODE
While in the PROGRAM MODE, changes may be made to parameters which affect the Instrument
operation. All parameters may not be accessible, as many are dependent on activation by another
parameter. Access is gained as follows:
ñ
Note: Refer to General Instrument Operations section for instructions on
identifying RUN and PROGRAM mode of operation.
From the Normal Display,
ÿø
key until the following is visible:
SELECT <->
CONFIGURATION
With CONFIGURATION shown in the lower display line,
ÿö
key. The following will
now be visible on the user display:
CONFIGURE <->
INSTRUMENT
SETTINGS
With INSTRUMENT SETTINGS shown in the lower display line,
ÿö
key. Available
parameters are:
INSTRUMENT TAG
[ USER ENTERED TEXT ]
ñ
NOTE: Refer to General Instrument Operation - Modifying Text
for information on this operation.
Definition: This text parameter defines the Instrument Tag that is
shown on the user display.
ÿø
TO ADVANCE TO NEXT SELECTION
Revision 3.0
Section 7
3
