5.1.2.
STLR - Shunt Position - PROGRAM MODE
While in the PROGRAM MODE, changes may be made as to which parameters display on the user screen, in
addition to which parameters print to the chart. All parameters may not be accessible, as many are dependent
on activation by another parameter. Access is gained as follows:
ñ
Note: Refer to General Instrument Operations section for instructions on identifying
RUN and PROGRAM mode of operation.
From the Normal Display,
ÿø
key until the following is visible:
SELECT <->
FUNCTION
SETUP
With FUNCTION shown in the lower display line,
ÿö
key. The following will now be
visible on the user display:
SELECT
FUNCTION
STLR XXXX XXXX
ñ
NOTE: XXXX will be vary depending on which options the unit has
ÿø
key until STLR is flashing,
ÿþ
key to select. Available parameters are:
STLR INPUT USAGE
[NORMAL]
[SIMULATED]
ÿü
to change,
÷
or
ø
to choose,
ÿþ
to save
Definition: This parameter selects NORMAL run mode, with a
SIMULATED run mode option for demonstration purposes.
The SIMULATED VARIABLES menu will allow changes
such as period and amplitude of the simulated variable to be
made.
ÿø
TO ADVANCE TO NEXT SELECTION
Revision 3.0
Section 5
4
