2.
Installation
The following section details mounting, installation, and wiring details for the AV-9900 Series HTST
Controller.
ô
CAUTION:
Be sure to thoroughly read the material in this section prior to installation. Data
tags for voltage and wiring are located inside the unit, viewable upon swinging
the chart plate forward.
2.1.
Unpacking
Remove the instrument and pen cartridge assembly from the shipping container and inspect for any damage
due to transit. If damage has occurred, report and file a claim with the carrier immediately. All packing
and shipping materials should be secured as proof of damage.
ñ
NOTE
:
Charts, pen cartridge, and included service manual are enclosed in a cardboard
box within the container holding the unit. Be sure to secure these items before
discarding shipping material.
Select a location for the instrument which is accessible, clean, well lighted and free from excessive
vibrations and wide variations in temperature. The instrument should be mounted vertically on a rigid
support (either wall mount or panel mount). Be sure to observe all local wiring codes.
2.2.
Mounting
Wall Mount:
Brackets supplied provide holes for ¼” machine bolts or
No.
14
wood
screws.
Panel Mount:
Four countersunk locations provided for ¼” machine bolts. Accessible by
swinging open door and chart plate - located on upper and lower lip of
case. Installer required to complete hole penetration through case
Dimensions
A = 16.77”
B = 12.6”
C = 14.12”
D = 7.747”
E = 5.24”
Panel Cutout
12.7” x 12.7”
Figure 1 - Case Dimensions
Revision 3.0
Section 2
1
