42
EN
Troubleshooting
Problem
Cause
Solution
Device can‘t be switched
on / OLED display stays
dark
Battery empty or wrongly polarized
Check polarity or insert fresh
battery.*
Screen set too dark
Use button 1 to make it brighter*
Device was previously switched off by
pressing a key
The device can also be switched
on/off without the flap by pressing
and holding key 4*
Device may be located in the Video
mode PAL or NTSC
Press button 1 for 7 seconds (see
p.33)*
Device cannot be swit-
ched off
Flap defective or torn off
The device can also be operated
without the flap, press and hold
key 4 to switch on/off (see quick
start guide p. 24)*
The image quality is
inferior
• Device is in manual calibration
mode
• Calibration was interrupted
• perform manual calibration (p.
32)
• in unsuccessful, perform NVFFC
(p. 32)
• if unsuccessful, turn device off
and on again*
Wrong battery type selected
Select correct battery type in the
BAT menu to activate the autos-
hutter*
*
If it still fails to function, refer to higher level maintenance.
For the further development of our products, it is
important to us to include the feedback of our custo-
mers in order to be able to improve and expand our
range of products four you.
We are looking forward to your ideas and sugge-
stions.
We have already received a lot of feedback from
our customers in the past. In this context, we have
been able to give free upgrades to the latest model
to particularly committed users according to their
feedback.
Your opinions and ideas are important to us
Contact us:
mail: info@andres-industries.de
phone: +49 30 45 80 39 00
web: www.andres-industries.de
