Wanguard 6.2 User Guide
Reports » Components
Inbound Bits/s
Inbound bits/second throughput and the usage percent.
Outbound Bits/s
Outbound bits/second throughput and the usage percent.
Received Pkts/s
Packet/s reported by the associated Sensors.
IPs (Int.)
IP addresses (from to the IP Zone) that send or receive traffic.
Dropped
Packets dropped by the Server Cluster.
CPU%
Percentage of CPUs used by the Sensor Cluster process.
RAM
The amount of memory utilized by the Sensor Cluster process.
Start Time
The time when the Sensor Cluster instance started.
Server
Which server runs the Sensor Cluster. Click to open a new tab with data specific to the server.
Administrators and operators can right-click to open the Server Configuration window.
Packet Sensors
The table is displayed while there is at least one active Packet Sensor.
Status
A green check mark indicates that the Packet Sensor is connected to Console. If you see a red
“X” instead, make sure that the WANsupervisor service is running and look for errors in the
event log (see page 69).
Sensor Name
Displays the name of the Packet Sensor and a colored square with the color defined in its
configuration. Click to open a new tab with data specific to the Packet Sensor. Administrators
and operators can right-click to open the Packet Sensor Configuration window.
Pkts/s (In / Out)
Inbound and outbound packets/second throughput after IP or MAC validation.
Inbound Bits/s
Inbound bits/second throughput after IP or MAC validation and the usage percent.
Outbound Bits/s
Outbound bits/second throughput after IP or MAC validation and the usage percent.
Received Pkts/s
The rate of sniffed packets before IP or MAC validation.
IPs (Int / Ext)
IP addresses that sent or received traffic. The Int(ernal)/Ext(ernal) IPs are the IPs inside/outside
the IP Zone. The Top Generator parameter from the Sensor configuration enables or disables
the monitoring of external IPs.
Dropped
Packets dropped by the packet capturing engine. A high number usually indicates a sniffing
performance problem.
CPU%
Percentage of CPUs used by the Packet Sensor process.
RAM
The amount of memory used by the Packet Sensor process.
Start Time
The time when the Packet Sensor started.
- 88 -
Summary of Contents for wanguard 6.2
Page 1: ......
