11
Step 6:
Install the 9 mm long Aluminum Spacer
(am-3426) on the center axle up against the
previously installed bearing.
Step 8:
Install a Gear Assembly onto each of
the NeveRest Motor shafts. These gears will
need to be of equal size in order for the gears
to mesh together.
Step 9:
Ensure that all of the gears are aligned
with each other and tighten the #10-32 Set
screws to lock all the gear assemblies in place.
Step 10
: Locate the bearing holes on the Tile
Runner Chassis. For standard configuration locate
the following holes on the chassis.
Step 11
:
Press three 6x12x4 flanged bearings
into the indicated holes from step 10 in the
TileRunner Inside Plate (am-3392_Inside), on
the same side of the plate that has two separate
flanges. Make sure the bearing flanges are flush
against the sheet metal.
Step 7:
Install one Gear Assembly onto the
center axle of the gearbox. Be sure to place the
boss of the Gear against the spacer. Tighten the
#10-32 set screw to lock the Gear Assembly in
place.
PicoBox Duo and Chassis Assembly Instructions
