14
PicoBox Duo and Chassis Assembly Instructions
Step 23
: Install a 0.25 in long Aluminum Spacer
(am-3424) onto the Center Shaft.
Step 24
: Install the Center Wheel Assembly onto
this shaft and over the spacer such that it is flush
with the bottom of the cavity in the pulley. Lock the
wheel in place using the #10-32 set screw on the
Nub.
Step 25
: Wrap two 93 Tooth Belts (am-3378) around the Pulley on the Center Wheel Assembly. Be
sure to wrap the belts around the lower Churro Extrusions in the drive module so they can be installed
on the Outer Wheel Assemblies.
