AIRPIVOT
11
5
ELECTRICAL INSTALLATION
WARNING!
Follow the instructions and recommendations contained in this section.
Failure to do so may result in
serious injury or death.
Install the control box at a distance less than 12 m from the fan
. Failure to do so the power supply of the
equipment may be insufficient
The Anemoi AIRPIVOT motor is controlled by an external control panel. The equipment automatically detects if the
signal it receives is analog or digital via Modbus.
All cabling must comply with national and local regulations on cable cross-sections and ambient temperature.
Copper (60°C/75°C) conductors are recommended.
To ensure the fan operation, the control box must be connected to the fan and the power supply.
The distance
between the control box and the equipment must be less than 12 m and the cable with a minimum section of 1.5
mm2. Follow any national or local regulation regarding electrical installations.
CAUTION!
Follow national and local electrical regulations.
Failure to do so may result in serious injury or death.
Check that power supply is disconnected before starting the installation.
Failure to do so may result in
serious injury or death.
Do NOT install the fan with wet hands.
Failure to do so may result in serious injury or death.
Less than 12 m
