Anemoment LLC
22
Data Logger 422 User Manual
DL422-E-Series MicroSD Card Insertion and Removal
Access the card connector by removing the four screws
from the base of the weather-tight enclosure and lift the lid.
Gently lift the black gasket to access the edge of the card
connector.
To remove a card gently press the edge of the card inward
toward the circuit board. When the card pops out, remove
it from the slot.
To insert, slide MicroSD Card into the slot with the gold
contact pins side facing down, until it clicks into place
remove and replace the battery.
Put the gasket back in place, and make sure that it is
properly seated on the raised edge.
Replace the lid on the gasket and inspect that the gasket is
positioned correctly between the lid and the base.
Tighten the four screws.
Figure 9: Accessing MicroSD Card
Connector in DL422-E-Series Unit
