5
5. SETUP OF THE GUN
CAUTION
USE CLEAN AIR FILTERED THROUGH AIR DRYER AND AIR FILTER.
WHEN USING THIS GUN FOR THE FIRST TIME AFTER PURCHASE, CLEAN FLUID PASSAGES AND
REMOVE RUST PREVENTIVE OIL BY SPRAYING CLEANER.
FIRMLY FIX PAINT HOSE TO SPRAY GUN, TO AVOID THAT DISCONNECTION OF IT, CAN CAUSE BODILY
INJURY.
1.
Flush fluid passages with a compatible cleaner.
2.
Firmly connect an air hose to air nipple G1/4”.
3.
Firmly connect a paint hose to fluid nipple G3/8".
4.
Test spray, adjust fluid output and as well as pattern width.
6. HOW TO OPERATE
Suggested atomizing air pressure is 2.0 to 3.0 bar (29 to 43.5 PSI).
Recommended paint viscosity differs according to paint property and painting conditions. 14 to 25 sec. / Ford cup#4 is recommended.
Set the spray distance from the gun to the work piece, as near as possible within the range of 130-200 mm.
The gun should be held so that it is perpendicular to the surface of the workpiece at all times. Then, the gun should move in a
straight and horizontal line. Arcing the gun causes uneven painting
.
7. MAINTENANCE AND INSPECTION
CAUTION
BEFORE CARRYING OUT MAINTENANCE AND INSPECTION ALWAYS OBSERVE WARNING INDICATIONS.
- NEVER DAMAGE FLUID NOZZLE TIP, FLUID NEEDLE OR AIR CAP HOLES.
- NEVER IMMERSE THE SPRAY GUN COMPLETELY IN LIQUIDS SUCH AS THINNER.
4. BOX CONTENTS
WHEN RECEIVING THE SPRAY GUN, MAKE SURE THAT IT HAS NOT BEEN DAMAGED DURING TRANSPORT OR STORAGE AND
ALSO CHECK THAT ALL THE FOLLOWING CONTENTS ARE INSIDE THE BOX.
TWISTED BRUSH ø 10 mm
SPRAY GUN
UNIVERSAL SPANNER
BRUSH
INSTRUCTION MANUAL
EN
WS-200SP | WS-200FT Pressure Spray Guns
Summary of Contents for WS-200 FT
Page 51: ...51 Comments ...
