12
FRYER PREPARATION FOR USE
“BOIL OUT” INSTRUCTIONS
New
ANETS
Fryers are leak-tested and cleaned
at the factory before shipping. Before using a
newly installed fryer for food preparation, clean the
kettle again, as follows:
1. Thoroughly wipe the interior of the kettle
with clean cloths. Open the front door on
the lower portion of the fryer to access the
drain ball valve. Open the drain ball valve
(by aligning the valve handle with the drain
ball valve) and wipe the entire drain line clean.
2. Close the drain ball valve (turn the valve han-
dle cross-wise to the drain ball valve). Fill
the kettle with water to about 3
“
from the
top. Add 1 to 2 cups of soap powder,
washing soda (trisodium phosphate), or
deep fat fryer kettle cleaner.
3. Perform the Lighting Procedure for the
fryer. (Refer to the Lighting Procedure
later in this manual.)
4. Set the thermostat to 190
°
F. Heat, but DO
NOT boil the water. Stir the water to dis-
solve the cleaning material.
7. Open the front door and mount the drain
extension to the drain ball valve. Position a
container (bucket) capable of holding VERY
HOT cleaning solution beneath the end of the
drain extension to hold the cleaning solution
being drained, as shown in Figure 5.
FRYER PREPARATION FOR USE
(Continued)
FRYER OPERATING INSTRUCTIONS
(Continued)
Figure 5. Draining The Kettle
8. Open the drain ball valve SLOWLY, to avoid
splashes while draining the cleaning solution
from the kettle.
9. Close the drain ball valve (valve handle
crosswise) and remove the drain extension.
Close the front door.
10. Safely dispose of the cleaning solution.
11. Fill the kettle with water to about 3
“
from
the top. Add 2 cups of vinegar to neutralize
the cleaning solution.
12. Repeat steps 3 through 10 of this procedure.
13. Thoroughly wipe the interior of the kettle and
the drain ball valve with clean, dry, wiping
cloths to remove ALL water.
14. Dry the kettle thoroughly because any re-
maining water can cause sputtering of hot
shortening when the kettle is later filled and
heated.
5. Clean the fryer kettle for at least 20 minutes.
Use a small hand mop (an optional brush can
be ordered for this purpose) to clean the
upper portion of the kettle (above the 3
“
waterline) and the top rim of the kettle.
6. Shut down the fryer using the Shutdown
Procedure for the fryer. (Refer to the Shut-
down Procedure later in this manual.) Allow
the water to cool slightly.
!
WARNING
Hot cleaning solution can cause severe
burns. Take care when handling hot clean-
ing solution to avoid spilling or splashing the
solution.
CAUTION
For fryers with built-in filter systems, DO NOT
pump the cleaning, or rinsing, solution through
the filter system, to avoid damaging the filter
system pump.
!
