a) The Main Engine Is Placed On The Flat Table.
b) The Cup Body Installed With The Speed Regulator Is
Placed On The Principal To Press Up And Down And It Is
Rotated Counterclockwise At Same Time So That The Clip
Foot On The Cup Is Locked With The Clipper Of Main Engine
Firmly.
c) The Feed Tray (Y Stripe Faces Upward) Is Installed In The
Rotating Shaft Of Speed Regulator (Pay Attention To The
Alignment).
d) The Cutter Head Of Slicing And Section Is Installed On The
Feed Tray (Pay Attention To Hexagonal Alignment) The Cutter
Head Of Slicing Knife Can Be Used In Front And Back Face.
The Front Face Is Slicing And Back Face Is Section. The
Slicing Knife Faces Upward For Slicing .On The Contrast, It Is
Tightened.
e) The Cropping Cover Is Placed On The Cup Body To Press
Up And Down And It Is Tightened Counterclockwise At Same
Time.
f) Please Operate The Engine With No More 5 Seconds
Before Processing The Food In Order To Prolong The Service
Life Of Engine.
g) The Food Materials To Be Sliced Or Cut Are Placed In The
Charging Opening For Slicing And Section. If Necessary, The
Charging Arm Presses The Food Materials By Applying The
Force Evenly.
h) When Cleaning The Food Materials Or Assembly, The At-
taching Plug Must Be Unplugged To Avoid Danger.
(4) Combination And Use Of Slicing And Section
transfer plate
feeding bar
transparent cover
mincing cup
FOOD
PROCESSOR
COMBINED MULTIFUNCTION
6
slicing blade
Food Processor
Thank You For Your Choice To Buy And Use The Series Combined Multifunction Food Processor. Please Read This Instruction
Carefully Before Use So As To Make The Functions Of This Product A Full User.
A. Engine
B. Driving Gear
C. Knob For Selection Of Speed
D. Bottom Cover
E. Knob For Quick Cleaning
F. Fixing Cramp
G. Cover Of Mixing Cup
J Mixing Cup
K Rub Seal Ring
L Assembly Of Blade
M Feeding Bar
N Feeding Passage
O Transparent Cover
P Juice Filer
Q Residue-Juice Separating Slot
R Safety Buckle
S Residue Collector
T Milling Cup
U Rub Seal Ring
V
Assembly Of Miffing Blade
W Cover Of Mincing Cup
X Mincing Cup
Z Juice Cup
Caution
1. The Device Should Be Stored In A Dry And Ventilated
Place When They Are Not In Use.
2. The Razor Blade Is Very Sharp, At Cleaning With
Replace The Agitation Knife Hour Must Look Out.
3. If The Supply Cord Is Damaged, It Must Be Replaced
By The Manufacturer Or Its Service Agent Or A Similarly
Qualified Person In Order
To Avoid A Hazard.
Model Number: LSU-1411
Q
FOOD
PROCESSOR
COMBINED MULTIFUNCTION
T
U
V
R
Z
S
W
X
P
O
M
F
G
J
L
K
B
A
E
C
