- 5 -
3269830_ut_GB_rev.2
ENGLISH
GB
SAFETY DEVICES
37M3202
A
B
C
D
E
F
G
37M3162
H
L
3168040
3084420
ɉɊɈɂɁȼɈȾɂɌȿɅɖɇȿɇȿɋȿɌɈɌȼȿɌɋɌȼȿɇɇɈɋɌɂɁȺɄȺɄɈɃɅɂȻɈɍɓȿɊȻɉɊɂɇȿɋɈȻɅɘȾȿɇɂɂɉɊȺȼɂɅ
ɆɈɇɌȺɀȺɂɗɄɋɉɅɍȺɌȺɐɂɂ
ȺɉɉȺɊȺɌȾɈɅɀȿɇɍɋɌȺɇȺȼɅɂȼȺɌɖɋəɋɈȽɅȺɋɇɈȾȿɃɋɌȼɍɘɓɂɆɉɊȺȼɂɅȺɆɂɂɋɉɈɅɖɁɈȼȺɌɖɋəɌɈɅɖɄɈȼ
ɏɈɊɈɒɈɉɊȼȿɌɊɂȼȺȿɆɕɏɉɈɆȿɓȿɇɂəɏ
The illustration shows the position of the signs
provided.
A)
Nameplate with manufacturer and applian-
ce data
.
B)
General hazard:
read the manual carefully
before carrying out any procedure.
C)
General hazard:
when washing the applian-
ce do not point pressurised water jets at
internal parts.
D)
General hazard:
all relevant regulations
must be complied with. “No liability is ac-
cepted in case of failure to comply with the
installation and commissioning instructions”.
E)
General hazard:
all relevant regulations
must be complied with. “Install in complian-
ce with the relevant regulations and use in
well ventilated premises only”.
F)
Burn hazard:
watch out for hot surfaces.
G)
CE marking
: this indicates that the equip-
ment is compliant with all relevant laws ap-
plicable to the product.
SAFETY AND INFORMATION SIGNS
H)
General hazard:
dry operation is forbidden.
L)
General hazard:
drain the well completely
after use.
A
B
B
C
C
Even if the equipment has all its safety devices,
if necessary, during the installation and connec-
tion other safety devices may be supplemented
in accordance with applicable laws.
The illustration shows the position of the devices.
A)
Gas supply tap:
for turning the connection to
the gas supply line on and off .
B)
Safety thermocouple:
cuts out the gas sup-
ply if the fl ame goes out.
C)
Pressure switch:
stops gas supply when
the water level in the tank drops below the
minimum level.
Important
Make a daily check that the safety devices are
properly installed and in good working order.
