- 10 -
IT
AUS
DE
FR
ES
2 - Rinse surfaces with drinking water and dry. Do
not use pressurised water jets.
3 - Take special care not to damage stainless steel
surfaces. In particular, avoid the use of corrosive
products and do not use abrasive materials or
sharp tools.
4 - Remove food residues immediately before they
set.
5 - Remove the limescale deposits which may form
on some of the appliance's surfaces.
CLEANING THE WELL
To carry out this operation, proceed as follows.
1- Switch the appliance off and leave it to cool (see
page7
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Remove the basket support structure (
A
).
4 - Drain and filter the oil (see page8).
5 - Apply a food-grade detergent to the inside of the
well.
6 - Rinse the well with drinking water and drain.
7 - Apply a specific product or a water and vine-
gar solution to the well to remove the deter-
gent residues.
8 - Rinse, empty and dry the well.
CHECKING GAS PRESSURE
To carry out this operation, proceed as follows.
1- Turn off the gas supply tap.
2 - Open the hatch (
A
).
3 - Undo the pressure connection screw (
B
).
4 - Connect the pressure gauge (
C
) to the pressure
test point.
5 - Turn the gas supply tap back on.
6 - Use the knob (
D
) to light the burner (see page7).
7 - Turn the knob (
E
) to the full flame setting (see
page7) then check that the pressure reading
complies with the values provided in the table at
the back of the manual.
8 - Turn off the burner, disconnect the pressure
gauge and restore the initial conditions after com-
pleting the operation.
A
IDM-39603311300.tif
A
E
C
B
D
IDM-39603311100.tif
