Angelus Model 180S Seamer Instructions
3 OF 9
9/22/99 - 18033005
4. CRT PAGE EXPLANTION
A. ANYTIME YOU DESIRE TO CHANGE FROM ONE PAGE TO ANOTHER, COMPLETE THE FOLLOWING
STEPS.
STEP 1.
PRESS THE CANCEL PUSH BUTTON
THE LOWER CONTROL PUSH BUTTON LABEL WILL BE “GET PAGE”.
THEN PRESS THE HARD PUSH BUTTON, TITLED GET PAGE,
STEP 2.
ON THE NUMERICAL KEY PAD, ENTER THE NUMBER OF THE PAGE YOU WANT TO CHANGE TO.
STEP 3.
THE SCREEN WELL ADVANCE TO THE SCREEN YOU HAVE SELECTED.
B. IN A MEMBRANE CELL, IN THE LOWER LEFT HAND CORNER, IF THERE IS A SMALL ARROW
POINTING TO THE RIGHT, THIS INDICATES THAT THIS CELL HAS A HARD PUSH BUTTON CONTROL
ASSOCIATED WITH IT. IT WELL BE LOCATED TO THE RIGHT AND WILL HAVE A LABEL JUST LEFT
OF IT AND WILL BE DESCRIBED FOR THAT CELL.
C. TO MOVE TO A PARTICULAR CELL, PRESS THE ASSOCIATED MEMBRANE KEY, AND THE SQUARE
CURSOR WILL MOVE TO THAT INTENDED CELL
5. CELL DESCRIPTIONS AND OPERATION
A. PAGE 0. MAIN SEAMER CONTROL.
A 1. START/STOP SEAMER
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE START/STOP
SEAMER CELL, THE CONTROL LABELS ASSOCIATED WITH THIS PUSH BUTTON ARE DIS
PLAYED TO THE RIGHT AS “STOP SEAMER”, ”SLOW’AND”FAST”.
BYPRESSINGTHEHARDPUSHBUTTON BY ANY LABEL, THE SEAMER WILL REACT TO THAT
FUNCTION. WITHIN THE CELL, THE TEXT WILL SHOW AS FOLLOWS WHICH STATE THE
SEAMER IS IN.
A 1.1
SLOW
A 1.2
FAST
A 2. SPEED CHANGE
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE SPEED CHANGE
CELL, THE CONTROL LABELS ASSOCIATED WITH THIS PUSH BUTTON ARE DISPLAYED TO THE
RIGHT AS “SPEED CHANGE SELECT”. BY PRESSING THE HARD PUSH BUTTON BY THIS LABEL,
THE SEANLER MODE OF OPERATION CAN BE TOGGLED BETWEEN “MANUAI:’ AND “AUTO”.
WITHIN THE CELL THE TEXT WILL SHOW WHICH STATE THE SEAMER IS IN.
A 2. 1
MANUAL
A 2. 2
AUTOMATIC
