Angelus Model 180S Seamer Instructions
7 OF 9
9/22/99 - 18033005
B. PAGE 1. SEAMER ALARM SCREEN CONTINUED;
B 6. HOLD DOWN BAR
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE HOLD DOWN
BAR CELL, WITHIN THE CELL THIS INDICATOR WILL SHOW THE STATUS OF THE HOLD DOWN
BAR BY THE FOLLOWING TEXT;
B 6.1
NORMAL
B 6.2
OPENED
B 7. DISCHARGE RAIL
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE DISCHARGE
RAIL CELL,WTMM THE CELL TI-ES INDICATOR WILL SHOW THE STATUS OF THE DISCHARGE
RAIL BY THE FOLLOWING TEXT; B7.1 NORMAL
B 7.2
OPENED
B 8. DISCHARGE GATE
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE DISCHARGE
GATE CELL, WITHIN THE CELL THIS INDICATOR WILL SHOW THE STATUS OF THE DISCHARGE
GATE BY THE FOLLOWING TEXT; B8.1 NORMAL
B 8.2
OPENED
B 9. FEED CHAIN CLUTCH
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE FEED CHAIN
CLUTCH CELL, WITHIN THE CELL TMS INDICATOR WILL SHOW THE STATUS OF THE FEED
CHAIN CLUTCH BY THE FOLLOWING TEXT;
B 9.1
NORMAL
B 9.2
OPENED
B 10. CONTROL RESET
SAME AS ON PAGE 0 CONTROL RESET
B 11. COVERSTACK
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE COVER STACK
CELL, WITIHN THE CELL THIS INDICATOR WILL SHOW THE STATUS OF THE COVER STACK BY
THE FOLLOWING TEXT-,
B 11.1 BOTH NORMAL
B 11.2 "A" STACK LOW
B 11.3 "B" STACK LOW
B 12. TRABON OIL SYSTEM
WHEN THE MEMBRANE KEY IS PRESSED AND THE CURSOR IS AROUND THE TRABON OIL
SYSTEM CELL, THE CONTROL LABEL ASSOCIATED WITH THIS PUSH BUTTON IS DISPLAYED
AS “PUSH TO MANUAL OIL”. BY PRESSING THE HARD PUSH BUTTON, THE TRABON PLTW WILL
START TO PLTW AND THE FAULT CIRCUIT WILL RESET. THE FOLLOWING TEXT WILL SHOW THE
STATE OF THE TRABON OIL SYSTEM IS IN;
B 12.1 NORMAL
B 12.2 LOW OIL LEVEL
B 12.3 LUBE CYCLE FAULT
