ANGELUS SANITARY CAN MACHINE COMPANY
SERVICE NOTICE
3 of 3
10/11/99-18059001
Model 140S and 180S Seamers
Cover Feed Systems
Procedures continued;
Feed Turret installation fixture #160S816 is designed to easily install the 75 lb. Feed Turret.
the fixture mounts directly to the face of the Can
Feed Drive Case Cover fasteners.
Remove four of the Drive Case Cover
M10 fasteners to install the fixture.
Use the levelling screws in the fixture to
maintain the Turrets position during
installation.
Swing the fixture away from the machine.
Carefully lift the Feed turret and place on
top of the Levelling screws.
Use the levelling screws to finalize the
Feed Turret position.
Carefully swing the Feed Turret in under
the Cap Feed Bracket and Separator
Assemblies.
Use the jack screw on the bottom of the
fixture to raise or lower the Feed Turret.