p.8
Anglerfish Crea�ve Ligh�ng
|
Anglerfish Trigger V
2.0
Menu LED Blinking Red and Blue:
If the menu LED blinks
red
and
blue
upon start up or during
opera�on this means that the batery voltage is low and that
batery needs to be replaced
.
Op�cal
Trigger not Working:
If the op�cal trigger does not
trigger
the remote strobe,
remove the fiber op�c cable from the unit and inspect the
small high power LED inside the op�cal bulkhead. Operate
the camera
strobe
serval �mes and see if the LED blinks
w
hile the camera
strobe
fires.
If the LED does flash bright,
the fault could be in the op�cal
cable or the strobe se�ngs. Make sure you f
ollow the strobe
manufacture
’
s se�ngs for opera�ng the remote strobe via
op�cal cable.
Inspect the op�c cable for bends or damage. We recommend
using only high quality mul�
-
strand op�cal sync cables.
Summary of Contents for TRIGGER V3.0
Page 1: ...USER GUIDE ANGLERFISH TRIGGER V3 0 ...
Page 2: ......