Animo
A 202 W
09/98
6
8.1How to descale the filter coffee
unit
•
The steps for descaling are equal for both
filter coffee units.
1.
Switch off the machine (fig. 2B).
2.
Slide the removable filter into the machine
3.
Place an empty jug under the lower hot plate.
4.
Dissolve 1 sachet for 50 grams of Animo
descaling agent remover in 1 litre of
lukewarm 60 -70˚C water (see instructions
for use on the labelling).
5.
Pour 1 litre of Animo descaling agent
remover into the reservoir (fig. 1E) and switch
on the machine (fig. 2B).
6.
Turn the selection switch (fig. 2C) to the half
position and press the start button (fig. 2D).
The solution will now begin to flow through
the system.
7.
Leave the reservoir lid open!
*
Attention! If the machine begins to
steam heavily, switch it off immediately
(fig. 2B).
Wait for 1 minute.
The solution will flow through automatically.
Switch the machine back on. Press the start
button (fig. 2D) as well.
8.
When half of the solution has run through
the machine, switch it off for about 2
minutes (fig. 2B). The solution will now
undergo a reaction with the lime scale.
9.
After the pause, switch the machine back
on and allow the rest of the solution to flow
through the machine. Press the start button
again (fig. 2D).
*
Attention! Keep an eye on the reservoir
while the solution is running through
the machine
. Turn the machine off as soon
as the reservoir is empty. Then rinse clean the
metal contacts in the cold water reservoir
with water or a wet cloth.
10. After descaling the machine, rinse thoroughly
by carrying out the normal coffee preparation
process 3 times (without paper filters and
coffee).
11. Clean the removable filter and jug
thoroughly. The filter coffee unit is now
ready to be used again.
8.2 How to descale the hot water
unit
1.
Remove the round black and the stainless
steel lid from the hot water reservoir (fig. 1G).
2.
Remove the larger pieces of deposit by
holding the machine upside down above the
sink so that the water and the loose pieces of
scale fall out.
Attention!
The coffee unit will
also empty! (see unit 5, “Prepation before
use”).
3.
Use a descaling agent to remove the
remaining scale. The hot water unit should
be refilled as described in unit 5,
“Prepation before use”.
4.
As soon as the hot water unit has heated
up, draw off one third (approx. 1.5L) of the
hot water.
Attention!
When the reservoir has
reached the correct temperature, it should
be switched off (fig. 2I). It should not be
switched on again during the descaling
process.
5.
Add two sachets for 50 grams Animo
descaling agent into the water. This will now
undergo a (frothing) reaction with the scale
deposits.
6.
Allow the solution to soak in for about 10
minutes until the frothing has stopped.
WARNING
-
Stay near the machine while
maintenance is being carried out.
-
When descaling the machine, always
observe the instructions for use
provided with the descaling agent.
-
When descaling the machine, it is advisable
to wear safety goggles and protective gloves.
-
Allow the machine to run through at
least three times after it has been descaling.
-
Wash your hands thoroughly after descaling.
-
The machine should not be submerged or
sprayed.
-
Have all repairs carried out by a specially
trained technician.
!
