ComBi
line
03/04
71
7.1.3
Cleaning weekly
A sachet of coffee fur remover is supplied with the machine.
Use is extremely simple.
Removal of coffee deposits from the inner pot.
1.
Fill half of the container with warm water and dissolve
a sachet of coffee fur remover in it.
2.
Let the solution work for 15 to 30 minutes, then empty
the container.
3.
Rinse the container thoroughly with hot water a few
times.
Removal of coffee deposits from the other parts.
1.
Take a bowl filled with abt. 5 liter warm water and
dissolve the coffee fur remover solvent from the sachet
in it.
2.
Put the parts that need to be cleaned in the bowl and
soak them for 15 to 30 minutes.
3.
Rinse several times with warm water. Repeat treatment
if the result is insufficient.
4.
Scatter coffee fur remover on very filthy spots and clean
with a wet brush.
7.1.4
Cleaning the tap
1.
Unscrew the top of the tap by turning it to the left.
2.
Pull the silicon sealer vertically away from the screw top.
3.
Put the parts to be cleaned in this solution and let it
work for 15 to 30 minutes.
4.
Then rinse off several times with warm water and put
back together in reverse order, repeat if the results are
insufficient.
Cleaning tap
Fig. 13
