17
2017/05 Rev. 0.0
EN
ComBi-Line
6.2
Removing the control panel
The control panel can be easily removed from the front part of the machine.
If the interface board [1.1] (see previous page) must be replaced, the new board is already equipped
with the latest software by the factory. After restarting the machine, the automatic ‘Installation menu’
starts. This installation menu can also be manually activated in the service menu: 2.10 START
INSTALLATION MENU.
Special settings, uploaded logos and dealer information on the previous interface board are lost and
must be uploaded again on the new interface board.
1. Firstly, unplug the machine from the mains.
2. Unscrew both screws [1] on the side.
WARNING
• The front part of the machine is still connected to the wiring.
3. Lift the panel a little [2] and move it a few centimetres away from the column.
4. Pull the connector from the interface board [3].
5. Pull the fastons from the ON/OFF switch [4].
1
2
3
4