Animo
TA 202 W
09/99
6
8.1How to descale the filter coffee
unit
•
The steps for descaling are equal for
both filter coffee units.
1.
Switch off the machine (fig. 2B).
2.
Slide the removable filter into the machine
3.
Place an empty thermoscontainer under
the filter.
4.
Dissolve 1 sachet for 50 grams of Animo
descaling agent remover in 1 litre of
lukewarm 60 -70˚C water (see instructions
for use on the labelling).
5.
Pour 1 litre of Animo descaling agent
remover into the reservoir (fig. 1D) and
switch on the machine (fig. 2B).
6.
Turn the selection switch (fig. 2C) to the
half position and press the start button
(fig. 2D). The solution will now begin to
flow through the system.
7.
Leave the reservoir lid open!
*
Attention! If the machine begins to
steam heavily, switch it off immediately
(fig. 2B).
Wait for 1 minute.
The solution will flow through
automatically. Switch the machine back on.
Press the start button (fig. 2D) as well.
8.
When half of the solution has run through
the machine, switch it off for about 2
minutes (fig. 2B). The solution will now
undergo a reaction with the lime scale.
9.
After the pause, switch the machine back
on and allow the rest of the solution to
flow through the machine. Press the start
button again (fig. 2D).
*
Attention! Keep an eye on the reservoir
while the solution is running through
the machine
. Turn the machine off as
soon as the reservoir is empty. Then rinse
clean the metal contacts in the cold water
reservoir with water or a wet cloth.
10. After descaling the machine, rinse
thoroughly by carrying out the normal
coffee preparation process 3 times
(without paper filters and coffee).
11. Clean the removable filter and
thermoscontainer thoroughly. The filter
coffee unit is now ready to be used again.
8.2 How to descale the hot water unit
1.
Remove the round black and the stainless
steel lid from the hot water reservoir (fig. 1F).
2.
Remove the larger pieces of deposit by
holding the machine upside down above
the sink so that the water and the loose
pieces of scale fall out.
Attention!
The coffee unit will also empty!
(see unit 5, “Prepation before use”).
3.
Use a descaling agent to remove the
remaining scale. The hot water unit should
be refilled as described in unit 5, “Prepation
before use”.
4.
As soon as the hot water unit has heated
up, draw off one third (approx. 1.5L) of the
hot water.
Attention!
When the reservoir has reached
the correct temperature, it should be
switched off (fig. 2G). It should not be
switched on again during the descaling
process.
5.
Add two sachets for 50 grams Animo
descaling agent into the water. This will
now undergo a (frothing) reaction with the
scale deposits.
6.
Allow the solution to soak in for about 10
minutes until the frothing has stopped.
7.
Allow the hot water reservoir to drain until
no more water comes out of the tap.
WARNING
-
Stay near the machine while
maintenance is being carried out.
-
When descaling the machine, always
observe the instructions for use
provided with the descaling agent.
-
When descaling the machine, it is
advisable to wear safety goggles and
protective gloves.
-
Allow the machine to run through at
least three times after it has been
descaling.
-
Wash your hands thoroughly after
descaling.
-
The machine should not be submerged
or sprayed.
-
Have all repairs carried out by a
specially trained technician.
!
