Animo
TA 202 W
09/99
4
4. CONTROL PANEL (FIG. 2)
filter coffee unit
A - Alarm lamp for heating element
B - On/off switch
C - Selection switch for full or half jug
D - Start switch
hot water unit
F - Alarm lamp for heating element
G - On/off switch
5. PREPARATIONS BEFORE USE
Before operating the machine, carry out the
following steps:
•
filter coffee unit:
1.
Connect the supplied water hose to the
coupling nut swivel joint at the rear of the
machine and to a manually-operated
water tap.
ATTENTION!
Use cold water only.
2.
Pour 2 Liter of cold water in both the cold
water reservoirs (fig. 1D).
3.
Wait for 3 minutes until the water has
entered the entire system.
4.
Slide both removable filter into the machine
and place an empty thermoscontainer under
the filters.
•
hot water unit:
5.
Remove the round black and stainless steel
safety lid from the hot water reservoir
(fig. 1F).
6.
Fill the hot water reservoir (fig. 1F) with 2
measuring jugs of water.
7.
After you have followed the instructions
above, place the plug in the socket.
8.
Turn on the filter coffee unit using the
switch (fig. 2B).
9.
Turn the selection switch (fig. 2C) to the
desired amount.
10. Press the start switch (fig. 2D) and the water
reservoir will fill up.
11. The orange alarm lamp (fig. 2A) on the
filter coffee unit will now remain lit until the
water has run through. The filter coffee unit
is ready for use when the lamp has gone out
again.
WARNING
*
Always remove the plug from the socket if the machine has to be opened for repair or
maintenance.
*
Do not position the machine in areas where the temperature drops below freezing point
because there is always water left in the system.
*
Always plug the machine into an earthed wall socket.
*
Do not submerge or spray the machine.
*
Have all repairs carried out by a specially trained technician.
*
If the machine is not used it is advisable to remove the plug from the socket and the tum off
the water tap.
!
