mark the wall or floor through the holes in the safe. The safe should be fixed as shown in following diagram. Ensure
no electrical cabling, gas or water pipes are hidden where you intend to drill. Using a 12 mm masonry drill bit, drill at
the marked locations. Insert the split tubes together with bolts, washers and wedge nuts into each hole. Pretighten
the bolts to fix the wedge nuts in the tubes. Then remove the bolts with washers. Locate the safe, add the washers and
tighten the bolts.
To register the fingerprint
Press the red button
while the door is open, you will hear several beeps and the fingerprint scanner
will light up
(3)
(5)
red. Immediately place your finger and keep it on the scanner
until two short beeps are heard. Then the green
(5)
LED
will light up with a long beep. This indicates the fingerprint is successfully registered. otherwise both red
(4)
(3)
and green LEDs
will blink with short beeps. Repeat above steps to register more ditferent fingerprints.
(4)
Note: Maximum 20 fingerprints can be registered.
Note: In order to improve the fingerprint identification, users may refer to the following advice:
• Keep the fingerprint scanner clean.
• It is better that each user registers 2-3 fingerprints.
• It is recommended for women and children to register with either a thumb or a middlefinger.
• When registering fingerprint, press gently with even power.
To set and change the user code
Press and hold the number key '1' until the green LED
is on. Input the original code (the default code is
) and
(4)
1234
press the ON/OFF-Button
to confirm. After hearing a long beep, input your new user code (4 to 8 numbers) and
(6)
press the ON/OFF-Button
.Then input the new code again and press the ON/OFF Button
to reconfirm. When a
(6)
(0)
long beep is heard, the user code is successfully changed. If both red and green LEDs
keep blinking with beeps,
(4)
it means wrong code is entered. To change the code, repeat above steps. Note: Each touch of the keypad will cause
the green LED
to flash and a short been to be emitted.
(4)
To open the safe door using the fingerprint
Press the ON/OFF-Button
and the fingerprint scanner
will light up red. Immediame place your finger and keep
(6)
(5)
it on the scanner
until the green LED
is on and a long beep is heard. Turn the knob
clockwise and pull to open
(5)
(4)
(1)
the safe. If both red
and green LEDs
keep blinking with short beeps. it means no registered fingerprint is detected.
(3)
(4)
To open the safe door using user code
Input your user code (4 to 8 numbers) and press the ON/OFF-Button
to confirm. After hearing a long beep, the green
(6)
light
will be on. Turn the knob clockwise and pull to open the safe.
(4)
Resetting the safe
Press and hold the red button
while the door is open. After a short beep, the green LED
will starlblinking for
(3)
(4)
about 10 seconds and stop with a long beep. Release the red button
then as the safe has been reset to the factory
(8)
default setting. All registered fingerprints have been deleted and the user code has been set back to the default
code
1234
.
How to use your override key
If you cannot open the safe using either fingerprint or code, push on the middle of the ovenide keyhole cover
to
(7)
slide it off. Then locate the keyhole to insert the override key and turn it anticlockwise. At the same time, turn the knob
clockwise and open the safe door. Do not keep the override key in the safe.
Producer:
ANKARO GmbH
Hauptstraße 6
D-14979 Großbeeren
