|
37
5.1.1. Mounting of the base
Screw the base with 4 screws onto the checkout desk.
The type and length of the screws depends on the material used for the checkout furniture
(wood, metal, plastic)
. Countersunk screws (M3) should be sufficiant.
5.1.2. Electronical connection
Warning!
A free wheel diode is necessary for the intended operation of a cashier
system / POS component (e.g. printers). Operation without a free
wheel diode is not allowed.
Place the round plug of the cable (3). in the port of the base and connect the other end to the
POS system.
5.2. Installation of the outer cassette on the base plate
Open the cassette.
Attention! Risk of injury!
When the cash cassette is opened, the lid's spring pushes it upwards
after opening (using the stick or the key). Please use your free hand to
hold the cassette and the lid.
If the cash cassette is
being installed without
lock, please use the stick to
open the cassette.
The needed drill can be
found below the cash
cassette.
slide the stick into the drill
and push the stick to the
left side.
Attention: the lid opens!