5
FOR A QUICK WASH UP
Between processing tasks, pour in some warm water into the chopping jar, turn and hold the speed
selector to “P” position a few seconds for quick cleaning.
KNEADING/MIXING
1. Firstly, assemble the driving shaft into the motor base. Make sure it is clipped into
position.
2. Place the chopping jar on the motor unit, aligning the arrow symbol on the chopping jar
with the unlock symbol on the motor unit. Slightly turn the chopping jar clockwise until
the chopping jar locks into the lock position on the motor base. Make sure it is
assembled in place correctly, otherwise the appliance will not operate.
3. Insert the plastic blade into the driving shaft in the jar securely.
4. Measure the flour with food pusher and put them into the jar. The maximum quantity of
flour is 375g.
5. Place the lid onto the chopping jar and turn it clockwise until the tab of the lid clicks
into slot in the jar handle. Make sure it is locked in position correctly, otherwise the
appliance will not operate.
6. Insert the food pusher into the feeding funnel.
7. Add one tablespoon oil into the appliance from feeding funnel. Connect the appliance
to power supply. Turn the speed selector to the “2” setting.
8. Then add water (the maximum water quantity is 225g) from the feeding funnel slowly
within 20s.
NOTE: the food pusher also can be used as measuring cup for measuring oil or water.
9. The proportion of the flour and water is 5:3. Make sure the quantity of the water is not more than the
maximum specified water quantity.
Note:
Add some more water if the processing speed slows down during operating so as to make the
motor run smoothly, otherwise the motor may be damaged. During kneading/mixing, to avoid
shaking, press the lid with one hand, and the other hand holding the handle.
10. Stop the process by turning the speed selector to “0” position as soon as the pastry starts to form a
ball.
Warning: The maximum operating time is 90 seconds. Allow it to rest for 2 minutes before using it
again. After 3 cycles of operation, allow the electric motor to cool down to room temperature for
approximate 30 minutes before using it again.
11.
Unplug the appliance, detach the cover, remove the plastic blade, then remove the dough.
CLEANING
1. Disconnect the power supply before cleaning.
2. Empty the jar and remove the lid, the plastic blade, and pusher. Immerse them in water and clean them
with a damp cloth or soft brush.
3. Wipe the outside of base with a damp cloth. Never immerse the motor base in water as electric shock is
possible to occur. Then dry thoroughly. Ensure the interlock area is free of food particles.
