2
2. Necessary safety instructions
●The device is not used for newborn baby.
●The device is not continuous monitoring device.
●JPD-FR100+ is not waterproof. Please do not douse it into water or other
liquids. Cleaning and disinfection procedure shall be in comply with the
instructions specified in [cleaning and storage]
●Please do not use the product if the temperature sensor or the Dual
mode infrared thermometer shows any sign of damage. Do not try to
repair the product if it is damaged. Please contact the nearest ANKOVO
Customer Service.
●JPD-FR100+ consists of precision parts with high quality. Please prevent
the product from falling off. Protection shall be provided for no intense
shock and vibration. Do not twist the Dual mode infrared thermometer and
the temperature sensor.
●
Operating Conditions:
Temperature: 10
C to 40
C
Humidity:
≤
80% RH, non-condensing
Atmospheric pressure: 860hPa to 1060hPa
●
Storage and Shipping Conditions:
Temperature: - 20
C to 55
C
Humidity:
≤
95% RH, non-condensing
Atmospheric pressure: 50hPa to 1060hPa
●
Battery Installation:
Put the two AAA batteries into battery compartment in correct polarities.
Push the battery cover horizontally along the arrow.
Notes:
☆
If you are the first time using the thermometer, please pull out the
Plastic sheet .
☆
Battery polarities should be correctly installed. Otherwise, damage
may be caused to the device.
☆
Please put in or remove batteries in right order, or may cause damage
to the device bracket.
☆
Please remove the batteries if the thermometer will not be used for a
long time.
Warnings
●Please keep this Dual mode infrared thermometer out of children’s reach
