3
d)
Store idle power tools out of reach of children and do not allow persons unfamiliar with the power tool or these instructions
to operate the power tool.
Power tools are dangerous in the hands of untrained users.
Do not let visitors touch the tool or extension cord. All visitors should be kept away from work area.
e)
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that
may affect the power tools operation. If damaged, have the power tool repaired before use.
Many accidents are cause by
poorly maintained power tools.
Inspect extension cords periodically and replace, if damaged.
f)
Keep cutting tools sharp and clean
, properly maintained cutting tools with sharp cutting edges are less likely to bind and are
easier to control.
g)
Use the power tools, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the
particular type of power tool, taking into account the working conditions and the work to be performed.
Use of the power
tool for operations different from intended could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by qualified repair person using only identical replacement parts, this will ensure that the safety of
the power tool is maintained.
Additional information shall be provided
a)
Instruction for putting into use
1.
Setting-up or fixing power tool in a stable position as appropriate for power tools which can be mounted on a support.
2.
Assembly
3.
Connection to power supply, cable, fuse, socket type and earthing requirements.
4.
Illustrated description of functions.
5.
Limitations on ambient conditions.
6.
List of contents.
b)
Operating Instructions.
1.
Setting and testing. 2. Tool changing.
3. Clamping of work.
4. Limits on size of work piece.
5. General instructions for use.
c)
Maintenance and servicing.
1.
Regular cleaning, maintenance, and lubrication.
2.
Servicing by manufacture or agent, list of addresses.
3.
List of user-replaceable parts.
4.
Special tools which may be required.
6) Clamp fixed position for 3cm Nylon Fixed-Wire
The clamp fixed position for 3cm Nylon Fixed-Wire is at 235mm start count from the top of the screwdriver flat surface (for
direct cable), as shown in Figure 1.
The clamp fixed position for 3cm Nylon Fixed-Wire is at 285mm start count from the top of the screwdriver flat surface( for
15 cm tail cable), as shown in Figure 2.
The clamp fixed position for 3cm Nylon Fixed-Wire is at 390mm start count from the top of the screwdriver flat surface (for
Iron ring socket type), as shown in Figure 3.
