14
4.
Set up functions
Functions
Settings
Description
Remark
1.
Auto learning
mode
P
+
S
->SL->SC->At->RC->SP->HC->LC->Ht->LT-->END
(Complete process)
Step1: Step1: Press P+S simultaneously for 5 sec., screen
will be flashing and greed LED will be on.
Step2: Start to set up functions step by step until shows HC,
use actual workpiece and screw to set up HC. (max.
fastening no. of thread)
Step3: When setting completes, press S to save settings.
Settings will be saved after screen flash 2 times.
1. If no workpiece and
screw were not used
during HC setting. It
will auto save as 99.9
2. After HC settings
complete, HT and LT
will also be shown.
2.
Connection to
wireless
controller
Up+Down
Set up this function to connect to wireless controller
(MY-WSIO)
1. Default set as not connected. Press Up+Down
simultaneously for 10 sec. to change connection status.
2. To disconnect, press Up+Down simultaneously for 10 sec.
to disconnect
5.
LCD
、
LED
、
BUZER status:
Screwdriver
status
Description
LED
Beep sound
Status
Power
SL
Display current screw list U1-U9
SC
Display current OK fastening no. 1~99
OK
LCD displays OK when screwdriver is proper
shut off each time.
Green LED
Flicks
1 short beep
sound
NOK
LCD display will show NOK when error
occurred.
Red
LED Flicks
1 long beep
sound
OK ALL
LCD will display OK ALL every time when a
batch completed.
Green LED
Flicks
1long beep
sound
At
When a batch complete, OKALL alarm will
trigger. Set alarm by sec.. (0.1~9.9)
Customize
