19
II.
How to change interface language?
Enter function "6.5 Language" to change. Select preferred language, English or Chinese.
III.
How to setup motor starting time on the machine?
Enter function "6.4.4 Wait HDD Time" to set device power up buffer time prior to copy. The time range is
from 3 to 30 seconds. The default is 15 seconds.
IV.
How to setup HDD transfer rate on the machine?
Enter function "6.6.8 Transfer Rate." Select proper transfer rate from UDMA 2~7.
The default is UDMA 5.
V.
How to setup motor stopping time on the machine?
Enter function "6.6.7 Stop Motor Time" to set device power down buffer time when tasks are finished. The
time range is from 1 to 20 seconds. The default is 5 seconds.
VI.
How to restore all settings back to factory default?
Enter function "6.7 Restore Default" and press <OK>. The system will clear all parameter back to the original
factory default settings.
[6. Setup]
5. Language
[Language]
English
Warning :
Clear Parameter To Default ?
Warning :
All Parameter was cleared !
[Transfer Rate]
UDMA 5
[Wait HDD Time]
15 seconds
[Stop Motor Time]
5 seconds
