Chapter 4 Operations for Each Function
4-114
4.8.6 Example of combination file creation
An example of combination file creation on the Combination File Edit
screen is provided below.
Figure 4.8.6-1 An Example of Combination File Creation
<1> Select a PC- or SG-side waveform pattern. In the above example, all
selected waveform patterns are on the SG-side.
<2> Set the level for each element. Since Add Pattern is selected in the
above example, the output power of the
MG3700A/MG3710A/MG3710E/MG3740A thus becomes equal to the
output power value set at the time of combination file selection when
Element1 is output, and the power ratio between Element1 and Add
Pattern becomes 0 dB.
<3> Set Repeat Count for each pattern. In this combination file, output is
performed as follows:
