2.2 Installation and Uninstallation Procedure
2-3
2.2 Installation and Uninstallation Procedure
The IQproducer
TM
for MG3700A/MG3710A/MG3710E/MG3740A can be
installed interactively by activating the setup program.
If resident virus check programs are running on your PC, exit them
before activating the IQproducer
TM
for
MG3700A/MG3710A/MG3710E/MG3740A setup program, as well as
other Windows applications in progress.
Note:
IF you upgrade the IQproducer
TM
for
MG3700A/MG3710A/MG3710E/MG3740A after the version 3.00
(hereafter referred to as “new software”) in PC in which the
IQproducer
TM
for MG3700A/MG3710A/MG3710E/MG3740A before
version 2.01 (hereafter referred to as “old software”) is installed,
please execute the setup file of the old software and uninstall it
before executing the setup file of new software. However, if the
short file name support was disabled on your Windows, old
software cannot be uninstalled. In this case, instead of uninstalling
the old software, execute the setup file of the new software and
specify the installation folder of the old software for the
Destination Folder, thereby installing the new software, while
overwriting the old one.
Note:
Versions 12.00 and later of this software are installed in a different
default destination folder than earlier versions. To install this
software in the same folder as versions prior to 12.00, set the
correct installation destination folder and then run the installer.
However, operation of this software is not assured if it is installed
in the path C:\Program Files when using Windows Vista or
Windows 7. When using Windows Vista or Windows 7, we
recommend keeping Destination Folder as the default install
destination.
Note:
This software of version 13.00 or later requires you to have
installed Microsoft Visual C++ 2010 Redistributable Package (x86).
In addition, this software of version 13.00 or later does not work on
Windows2000.
