36
(b) To cancel the setting
eq
\x(OFF-C) --------------------------
The "OFF-C" display at the upper right
disappears and function returns to the
ordinary state from the Off Center state.
5.4.15 Setting of the SLEEP function(SLEEP)
This function sends a 30-second-transmissions during pre-fixed hours. After a transmission, a power-saving
mode is entered with the screen in ST'BY state (the scanner-OFF state) and the LCD backlight turned off. This action
is repeatedly executed.
Usage example, set a guard zone and have the warning signal automatically confirmed every prefixed period.
Press the "SLEEP" key. Every pressing the key, "SLEEP" function will be set as 5-minutes, 10-minutes, 15-
minutes, or off.
When a transmission is conducted after setting a SLEEP mode, a ST'BY state is entered and the backlight turns
off after a 30-second-transmission. (Power-saving mode). Two minutes before the fixed time the backlight turns on
and the 2-minute timer starts. Then, at the fixed time another 30-second-transmission begins. This series of actions
are repeated. If any one key is pressed during the course of this action, the SLEEP function will be canceled.
Note: Please refer to "5.5.2.4 Setting of the SLEEP function(SLEEP)".
(1) Setting procedure
eq \x(SLEEP)
-(Select 5min.) eq \x(ENT)
eq \x(POWER)- 30-second-transmission
every 5 min.
transmission ON
eq \x(SLEEP)
-(Select 10min.) eq \x(ENT)
eq \x(POWER)- 30-second-transmission
every 10 min.
transmission ON
eq \x(SLEEP)
-(Select 15min.) eq \x(ENT)
eq \x(POWER) - 30-second-transmission
every 15 min.
transmission ON
eq \x(SLEEP) -(Select OFF) --------------------------------------- SLEEP function is
turned OFF
Setting completed
5.4.16 Tuning adjustment (TUNE)
(1) When the "TUNE" key is pressed, the TUNE display on the upper-right side of the screen will be reversed
as 35 and the adjustable state will be entered.
(2) When the control knob is turned, the figure will be shifted within a range of 0 and 99, and the receiver
tuning can be manually adjusted.
(3) After the adjustment is finished, press the "ENT" key to exit from the adjustment state. If some other
function key is pressed, shift to that function will take place.
