Anslut 012208, Operating Instructions Manual

EN

8

TECHNICAL DATA

Rated voltage  

230 V ~ 50 Hz

Output 

3,6 W

No. of LEDs 

200

Protection rating 

IP20

ASSEMBLY

1.  Remove the parts from the packaging.

     FIG.   1

2.  Angle out the foot of the Christmas tree 

so that it is at 90° between the four feet. 
Put the bottom pole (1) in the foot.

     FIG.   2

3.  Put the top pole (2) in the bottom (1).

     FIG.   3

4.  Put the bottom part of the tree on the 

pole. 

     FIG.   4
     FIG.   5

5.  Fold out the branches.

     FIG.   6

6.  Put the top part of the tree over the 

bottom. Connect the contact parts 
together.

     FIG.   7 

7.  Place the tree in the required place and 

plug the plug into a power point.

SAFETY INSTRUCTIONS

•  Do not connect the product to a power 

point while the product is still in the pack.

•  Only intended to be used indoors.
•  Check that no light sources are damaged.
•  Do not connect two or more products 

together to a power source.

•  No parts of the product can be replaced, 

or repaired. The whole product must be 
discarded if any part is damaged.

•  Do not use sharp or pointed objects 

during assembly.

•  Do not subject the power cord or wires  

to mechanical stress. 

•  This is not a toy. Be careful if using the 

product near children.

•  Disconnect the transformer from the 

power point when the product is not  
in use.

•  The product is not intended to be used as 

general lighting.

•  Recycle products that have reached the 

end of their useful life according to local 
regulations.

     WARNING!   
The product must only be used when all the 
seals are correctly fitted.

SYMBOLS

Approved in accordance with the 
relevant directives.

Recycle discarded product 
in accordance with local 
regulations.