EN
13
SYMBOLS
Read the instructions.
Must not be covered.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output
2000 W
Safety class
I
Protection rating
IP20
Size
36.5 x 41.5 x 24 cm
Weight
3.8 kg
INSTALLATION
1. Place the product on its side.
2. Put one leg in each corner and fit them
with three screws for each leg.
3. Tighten the screws clockwise and check
that the legs are firmly in place.
4. Stand up the product and check that it is
stable.
5. Place the product in the required place
and plug the plug into a power point.
The product is now ready to use.
NOTE:
The product must be placed on a level, stable
surface.
USE
1. Plug the plug into a power point.
2. Select the required setting with the
thermostat dial.
3. Select the button marked
I
for low heat.
4. For more heat first press the button
marked
I
and then the button marked
II
.
5. For flame effect press the button marked
–
/
0
to start or switch off the flame
effect.
OVERHEATING PROTECTION
If the product stops working switch it off, pull
out the plug, and check that the inlet or outlet
openings are not blocked. Wait at least 10
minutes so that the overheating protection has
time to reset before starting the product again.
If the product still does not start, take it to an
authorised service centre to be checked and
repaired.
NOTE:
The plug must be unplugged for at least
10 minutes before the product is restarted.
MAINTENANCE
• Switch off the product, pull out the plug,
and allow it to cool before cleaning.
• Wipe the product with a damp cloth.
• Do not use petrol, detergent or solvent.
• Store the product in a dry, clean place and
protected from dust when not in use.
