EN
8
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz/31 V
Output
6 W
No. of LEDs
300
Protection rating
IP44
INSTALLATION
1. Remove the parts from the packaging.
2. Angle out the foot of the Christmas tree
so that it is at 90° between the four feet.
3. Put the bottom part of the tree in the
foot.
4. Put the middle part in the bottom part.
5. Put the top part in the middle part.
6. Connect the contact parts together.
7. Fold out the branches.
8. Place the tree in the required place and
plug the plug into a power point.
SAFETY INSTRUCTIONS
• Do not connect the product to the mains
while still in the pack.
• Check that no light sources are damaged.
• Do not connect two or more products
together to a power source.
• No parts of the product can be replaced,
or repaired. The whole product must be
discarded if any part is damaged.
• Do not use sharp or pointed objects
during assembly.
• Do not subject the power cord or wires to
mechanical stress.
• This is not a toy. Be careful if using the
product near children.
• Disconnect the transformer from the
power point when the product is not in
use.
• The product is not intended to be used as
general lighting.
• Recycle products that have reached the
end of their useful life according to local
regulations.
WARNING!
The product must only be used when all the
seals are correctly fitted.
SYMBOLS
Approved in accordance with the
relevant directives.
Recycle discarded product
in accordance with local
regulations.
