EN
44
DIScHARGE
When discharging,
1
First remove the front panel
2
Then connect a drain hose to the discharge connector and open the ball valve (figure 8)
mEcHANIcAL TEmpERATURE cONTROL
• The control is used to start the built-in 2 kW electric heater cartridge
• The water temperature can be set to between 30-75°C
• Turn the control clockwise to set a higher temperature (figure 9)
• The electric heater cartridge only operates when the water temperature is lower than the pre-set
temperature
AUTOmATIc VENTING VALVE
NOTE.
• The lid should be closed when the tank has been vented after being refilled
• Open it manually every two months to vent the system
• The installation, planning and maintenance of venting should be carried about my a qualified
technician with knowledge about standards and local regulations as well as experience with this
type of equipment
The automatic venting valve (figure 10) is used to automatically vent the water system while
it is being refilled and while it is running
15 mm
Discharge
Hose
8
9
