ENGLISH
68
Sensor in tank
The other sensors are placed in the tank and the bottom tank sensor is placed in connection with
(somewhat over) the return to the solar heating circuit from the tank.
Recommendation
The control centre should be set to a high value to allow the tank to be fully charged before the circulation
pump is switched off. For connection to an Anslut multi-functional tank we recommend that the
temperature is set to 85°C. Check the recommendations of the tank manufacturer for maximum permitted
working temperatures. In order to lower the temperature when necessary in the lower part of the tank
(and avoid the solar heating pump stopping and thereby risking that the glycol mixture boils in the solar
collector), emergency cooling with a thermostat can if necessary be installed to the tank (decided by
technician on site).
COMMISSIONING
A.
Install the vacuum tubes in the solar collector frame after the piping has been routed and the
system filled and vented, and after the control centre sensors have been connected. (If the vacuum
tubes have already been installed, we recommend filling in the morning when the heat pipes are
cool, and that the tubes are covered during the filling work.)
B.
Mix glycol (propylene glycol) and water in equal parts (50%) to ensure freeze-protection down to
approx. -30 degrees. Check the freezing point and acidity by means of a propylene glycol tester.
The colour of the mixture should be pale yellow and transparent. (The glycol mixture should be
replaced if the pH-value as a result of severe boiling gradually becomes less than 7 and if the
glycol mixture visible in the flow meter on the drive package has become brown coloured.)
Summary of Contents for 417-031
