Antaira Technologies - Industrial Wireless Access Points
ARS-7235-PSE-AC Series - Hardware Manual - v1.0
Diagnostics
Red
Flashing
Unit not ready / Boot sequence
Off
Unit ready
ETH Port 0
(Upper LED)
Green
On
Connected to network, 10/100/1000Mbps
Flashing
Networking is active
Off
Not connected to network
ETH Port 0
(Lower LED)
Amber
On
Link established
Off
No link detected
ETH Port 1
(Upper LED)
Green
On
Connected to network, 10/100/1000Mbps
Flashing
Networking is active
Off
Not connected to network
ETH Port 1
(Lower LED)
Amber
On
Supplying power to PD
Off
Not supplying power to PD
Table 2.1 - LED Indicators
Note:
“P1” is the abbreviation for “Power 1”, “P2” is for “Power 2”, “LNK” is for “Link”, and “ACT” is for
“Activity”.
2.5 Reset Button
There is a “reset” button located on the front panel of the industrial wireless access point that helps users
to reboot, restore default, or save running configurations by pressing the button for different seconds.
Please refer to Table 2.2 for the timing and function.
Seconds
Function
4~6
Reboot the wireless access point
7 or more
Restore factory default
Table 2.2 - Reset Button Functions
6
