Antaira Industrial Ethernet Switches
LMP-0602-24 Series User Manual V1.1
28
[RPL Owner Node]
There is only one RPL Owner Node could be set in a ring network. In order to set up the
RPL Owner Node, choose a switch and enable “Protocol” under the ERPS Configuration
interface, and follow below steps and use below figure 5.25 as example:
Step 1:
Choose a specific port from the dropdown box next to “ring port 0”,
and set
it as “Owner” node by clicking the dropdown box next to “Role” below “ring port
0”.
At this point, “Port 1” was chosen as example.
Step 2:
Choose a specific port from the dropdown box next to “ring port 1”, then
set it as “Normal” from the dropdown box next to “Role” (which locates
below “ring port 1”). At this point, “Port 2” was chosen as example.
Note: The port number of “Ring Port 0” and “Ring Port 1” cannot be duplicated.
After the configurations, press the “Apply” button on the right bottom corner to save
the setting.
Please be aware, when the revertive mode is set to “Yes”, the ring will recover same as
above figure 5.24 after the ring state form ABNORMAL to NORMAL in 5 minutes.
Otherwise, the blocked port will remain blocked permanently unless users reconfigure it.
Figure 5.25 – RPL Owner Node Setup Example
