Antaira Industrial Ethernet Switches
LMX-0601G-SFP Series User Manual V1.0
10
2.7 Wiring the Power Inputs
Please follow the steps below to insert the power wire.
1. Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-)
contacts on the terminal block connector as shown below in
Figure 2.6
.
2. Tighten the wire-clamp screws to prevent the wires from loosening, as shown below in
Figure
2.7
.
Note
Only use copper conductors,
60/75
°
C
, tighten to
5lbs.
The wire gauge for the terminal block should range between
18~20 AWG
.
Figure 2.7 - Power Terminal Block
Figure 2.6 - Power Terminal Block
