Antaira Industrial Ethernet Switches
LMX-0601G-SFP Series User Manual V1.0
25
5.5.3 Before Configuring ERPS
Before configuring ERPS, the rapid spanning tree protocol (RSTP), or multiple spanning tree
protocol is required to disabled, because only one protocol can be exclusively running within a
switch. Below are the steps to disable RSTP or MSTP.
Step 1:
Login to the switch with a web browser.
Step 2:
Open the “RSTP Configuration” page under the “Spanning Tree” manual as
below
Figure 5.17
.
Step 3:
When the RSTP/CIST Configuration page shows up, set “Mode” to “Disable” as
shown in
Figure 5.18
.
Figure 5.17
– Spanning Tree Manual
Figure 5.18
– RSTP/CIST Configuration Interface
