Antaira Technologies - Industrial Ethernet Switches
LMX-2602G-SFP Series Hardware Manual V1.0
12
4. Hardware Installation
4.1 Installation Steps
T
his section will explain how to install Antaira Technologies’ LMX-2602G-SFP series: 26-Port Industrial
Gigabit Managed Ethernet Switches with 24*10/100/1000Tx and 2* Gigabit Combo Ports (2*10/100/1000Tx
RJ45 and 2*100/1000 SFP Slots).
Installation Steps
1. Unpack the industrial Ethernet switch from the original packing box.
2. Check if the rack-mount bracket is screwed on the industrial Ethernet switch.
•
If the rack-mount bracket is not screwed on the industrial Ethernet switch, please refer to the
Rack Mounting
section for rack-mount bracket installation.
3. Power on the industrial Ethernet switch and then the power LED light will turn on.
•
If you need help on how to wire power, please refer to the
Wiring the Power Inputs
section.
•
Please refer to the
LED Indicators
section for LED light indication.
4. Prepare the twisted-pair, straight-through category 5 cable for Ethernet connection.
5. Insert one
side of the RJ45 cable into switch’s Ethernet port and on the other side into the
networking device’s Ethernet port, e.g. switch PC or server. The Ethernet port’s (RJ45) LED on the
industrial Ethernet switch will turn on when the cable is connected to the networking device.
•
Please refer to the
LED Indicators
section for LED light indication.
6. When all connections are set and the LED lights all show normal, the installation is complete.
4.2 Maintenance and Service
•
If the device requires servicing of any kind, the user is required to disconnect and remove it from its
mounting. The initial installation should be done in a way that makes this as convenient as
possible.
•
Voltage/Power lines should be properly insulated as well as other cables. Be careful when handling
them so as to not trip over.
•
Do not under any circumstance insert foreign objects of any kind into the heat dissipation holes
located in the different faces of the device. This may not only harm the internal layout, but might
cause harm to user as well.
•
Do not under any circumstance open the device for any reason. Please contact your dealer for any
repair needed or follow the instructions within the manual.
•
Clean the device with dry soft cloth.
