Antaira Technologies - Industrial Ethernet Switches
LNX-0802C-SFP Series User Manual V1.0
12
2.8 Wiring the Fault Alarm Contact
The fault alarm contact is in the middle of the terminal block connector as the picture shows below
in
Figure 2.16
. By inserting the wires, it will detect the fault status including power failure or port
link failure (managed industrial switch only) and form
a normal open circuit. An application
example for the fault alarm contact is shown below in
Figure 2.16
.
**Note:
The wire gauge for the terminal block should range between
12 ~ 24 AWG
.
If only using one power source, jumper Pin 1 to Pin 5 and Pin 2 to Pin 6 to
eliminate the power fault alarm.
Figure 2.16
Wiring the Fault Alarm Contact
