41
• Release the UP button and place yourself on the upper step,
pulling the device towards the second step.
• Repeat the cycle for the rest of the stairway
The stairs have ended
• Turn the key of the panel to O (OFF) and remove it to ensure
that no one other than the qualified operator can use the
device.
To go down down stairs
1 Turn the key of the panel to I (ON) and verify the battery
charge level.
2 Position (at least for the first few time) the speed variator
on the SLOW position.
2 Adjust the potentiometer (10) to the desired speed. A low
speed is advisable the first few times.
press with your foot if the
passenger is very heavy
3 Set the movement mode selector switch
(14) (continuous cycle/single step) to the
“single step” position ( ).
In this way, the device will stop on the next
step, even if the button is held down.
If the selector switch is on the ( ) posi-
tion, on the other hand, the aid will continue
its movement continuously as long as the
button is held down.
4 Check that the emergency button (6) is
released, following the RESET instructions
printed on the button itself.
4.2
4
5 Ensure that the passenger has the seat belt fastened
6 Take firm hold of the handlebar and tilt the device until the step blocking wheels
4
are inserted; these control the wheel
brakes (4.2) and are therefore very important for safety.
7 Move carefully to the first step so that you are fully straight with the direction of the stairs.
8 Warning! push the device forwards until the wheel block is activated:
The wheels are automatically blocked when the safety equaliser bar
4
is away from the surface.
