5
© 2019 Antari Lighting and Effects Ltd.
www.antari.com
Please aim the key on the PowerCon terminal of the power cord to the slot of the
connector on the machine, plug it in and turn it about 10° clockwise until the power
cord is completely fixed. The upper power cord is for the fog generator and the bottom
one is for the compressor. (refer to figure 2 and 3)
Before connecting the machine to power supply, make sure to check the needed
voltage and watt indicated on the metal plate of the machine.
Connect the machine with the black fog conducting hose; it is a three-meter pipe. The
length of the pipe can be adjusted to fit the actual need. (refer to figure 4)
Fill Antari FLL Low Fog Effects Fluid to the tank, tighten the tank cap. (refer to figure
5)
Figure4
Figure5
Operation
1.
After confirming the voltage, connect the power cord to a grounded outlet then turn
on the lower power switch and then the higher one. The warmup starts now, and the
TFT touch panel will show the percentage of the whole warmup process until 100%
that the warmup is completed.
Figure
Figure