16
1.
With the motherboard tray on a flat surface, lay the motherboard on the tray and align it with the standoff
holes on the motherboard tray and remember or mark which holes are lined up (
Figure 23
).
2.
Now remove your motherboard by lifting it up.
3.
Install standoffs as needed
(Figure 24)
and put the motherboard back in.
4.
Screw in your motherboard to the standoffs with the provided motherboard mounting screws
(Figure 25)
.
Caution:
Make sure to remove any
unused
motherboard standoffs. They may come into contact with the
back of the motherboard and may electrify your chassis exterior if left connected.
Note:
This section assumes that you have removed the motherboard tray in section 2.5. If you are
installing a motherboard directly into the chassis, lay the chassis on its side with the drive mounts on the
right.
Figure 23 – Motherboard tray with motherboard
Figure 24 – Motherboard tray with preinstalled standoffs and additional
standoff holes identified
Figure 25 – Screwing in the motherboard after standoffs are installed
All manuals and user guides at all-guides.com
all-guides.com
Summary of Contents for Super LANBOY
Page 4: ...4 INTRODUCTION SECTION 1 All manuals and user guides at all guides com...
Page 8: ...8 HARDWARE INSTALLATION SECTION 2 All manuals and user guides at all guides com...
Page 19: ...19 FRONT I O PORTS SECTION 3 All manuals and user guides at all guides com...
Page 23: ...23 COOLING SYSTEM SECTION 4 All manuals and user guides at all guides com...
