22
3.6
R
EWIRING
M
OTHERBOARD
H
EADER
C
ONNECTIONS
There may come a time when you need to reconfigure the pin-out of a motherboard header connector. Examples could
be for your USB header, audio input header, or some other front panel connector such as the Power Button connector.
Before performing any work, please refer to your motherboard user’s manual or your motherboard manufacturer's
website to confirm the pin-out needed for your connector. We strongly recommend making a notated drawing before
beginning work so that you can recover if your work gets disturbed.
1.
Determine which wires you need to remove in order to rewire your plug to match the USB pin-outs on your
motherboard (refer to your motherboard user’s manual). Working on one connector at a time, use a very small
flathead screwdriver or similar tool to lift up on the black tab located beside the gold posts (squares). This will
allow you to easily slide out the pins from the USB plug.
2.
Working carefully so as not to damage the wires, connectors, or pins, slowly remove the pin from the
connector. Repeat these steps for each wire you need to change.
3.
Working carefully so as not to damage the wires, connectors or pins, slowly insert the pin into the correct slot
of the connector then snap closed the black tab that was lifted in step 1. Repeat these steps for each wire you
need to change.
Figure 31 – Front panel headers
All manuals and user guides at all-guides.com
Summary of Contents for Super LANBOY
Page 4: ...4 INTRODUCTION SECTION 1 All manuals and user guides at all guides com...
Page 8: ...8 HARDWARE INSTALLATION SECTION 2 All manuals and user guides at all guides com...
Page 19: ...19 FRONT I O PORTS SECTION 3 All manuals and user guides at all guides com...
Page 23: ...23 COOLING SYSTEM SECTION 4 All manuals and user guides at all guides com...